AccessMyLibrary provides FREE access to over 30 million articles from top publications available through your library.
Create a link to this page
Copy and paste this link tag into your Web page or blog:
Every once in a while, a product comes along that really strikes one as being unique. The Tivoli Model One radio is just that kind of product. While its configuration harkens back to the opening era of radio, its technology and construction are state-of-the-art. Clearly one of the principles employed in the design was simplicity. Lets start with the obvious--the front control panel. Here there are just three controls: an Off-FM-AM selector, Volume control and Tuner knob/Indicator dial. That's it! Well, I guess we also have to count the speaker grill, green LED power-on indicator and the larger yellow LED tuning indicator. Consistent with the keep-it-simple philosophy and heritage it is monophonic! (More about that later.)
The unit is 4.5 inches high, 8.375 inches wide and 5.25 inches deep, which makes it somewhat diminutive for a tabletop radio (certainly smaller than an original vacuum tube radio would have been). The rear panel includes an internal/external antenna switch along with a 75-Ohm Type F connector for the external antenna connection. There are also aux in, headphones and Rec out stereo mini connectors (monophonic sound only). To supply power there is a power-cord connector and an external power connector (12-16 VDC power supply). The case is a wooden box with four non-marring feet. It comes in three color combinations of front panel and case: Cobalt Blue/Cherry, Hunter Green/Maple and Silver/Walnut. The bottom of the unit has a 1.125 inches-in-diameter base port for the internal speaker--a heavy-magnet, long-throw, three-inch driver. It weighs approximately 5.0 pounds with a very solid feel and top-notch fit-and-finish. It comes with a generous detachable power cord (approximately 9 feet 10 inches in length), a single wire antenna (approximately 50 inches in length) with a Type F connector, a 4-page Owner's Manual (card) and a one page safety instruction card.
Operation is quite straightforward. Rotating the power switch to either the FM position or the AM position turns on the unit. It has a solid feel but is, perhaps, a bit on the smallish side ergonomically. Doing so illuminates the green power-on indicator. Volume is set with the volume control (same size as the power switch) which has a nicely damped feel. Radio stations are selected by rotating the tuning knob. Tuning is a very smooth process where the inner tuning knob has a 5:1 ratio to the outer tuning indicator ring. The yellow tuning indicator LED changes intensity with signal strength as the tuning knob is adjusted. The frequency stenciling on the front panel is quite clear. The order of the AM frequencies, since they are on the lower half of the dial, might seem a little "strange" but maintain the "normal" orientation of turning clockwise for higher frequencies. Out-of-the-box operation only requires that the power cord be attached to the rear panel and a quick check made to see that the antenna switch is in the internal position.
Performance, without an extensive test bench, is necessarily a subjective business. None-the-less, there are several performance areas that are worth trying to characterize. Of primary interest for a radio those are sensitivity, quieting (s/n), and channel separation. No doubt most of us are also inquisitive about sound quality for such a small package. So here goes.
Taking FM first, the unit does a credible job of pulling in all of our local stations (about 13 of them) just on the internal antenna. It also does well on the ten or so distant (high ...